VW Bzb engine

The 1.8-liter turbocharged engine Volkswagen BZB 1.8 TSI was produced from 2007 to 2010 and installed in popular models such as the Passat B6, Seat Toledo, and Audi A3. There was also an engine designated as BYT, which is considered an equivalent of this engine. The EA888 gen1 series also includes the following power units: BYT, CABA, CABB, and CABD.

Technical specifications of VW BZB 1.8 TSI engine.

Exact capacity1798 cm³
Power systemdirect injection
Engine power160 HP
Torque250 nm
Engine blockcast iron R4
Block headaluminum 16v
Cylinder diameter82.5 mm
Piston stroke.84.2 mm
Compression ratio9.6
Engine featuresDOHC
Hydraulic compensator. tak
Timing drivechain
Timing phase adjusterat the inlet
TurbochargingKKK K03
What oils to use4.6 liters 5W-30
Fuel type95
Environmental classEURO 4
Approximate life expectancy300 000 HP

Fuel consumption VW Bzb engine

Using the example of the 2008 Volkswagen Passat B6 with a manual gearbox:
City10.4 litry
Route6.0 litry
Mixed7.6 litry

Engine Overview and Common Failures

The dry weight of the BZB engine according to the catalog is 154 kg. The engine number for BZB is located at the junction with the gearbox. This motor is prone to oil consumption only if the crankcase ventilation system becomes clogged. The timing chain here quickly stretches and can jump after being parked in gear. Ignition coils do not last long here, usually due to bad or old spark plugs. The most common cause of engine idle fluctuations is carbon deposits on the intake valves. The swirl flaps in the intake manifold also get dirty and stuck due to carbon deposits.

Engine Vw Bzb

Audi
A3 2 (8P)2007 - 2010
Seat
Altea 1 (5P)2007 - 2009
Leon 2 (1P)2007 - 2009
Toledo 3 (5P)2007 - 2009
Skoda
Octavia 2 (1Z)2007 - 2008
Superb 2 (3T)2008 - 2010
Volkswagen
Passat B6 (3C)2007 - 2010

See Also

Audi Aeh engine

The 1.6-liter, 8-valve Audi 1.6 AEH engine was produced by the corporation from 1996 to 2007 and installed in popular models such as the A3 8L, Golf 4, and Toledo 2 platforms. This engine was developed in accordance with Euro 2 emission standards: it does not have exhaust gas recirculation (EGR), it has one lambda sensor, and an air reserve control valve (DMRV) instead of an additional intake throttle valve (DAD). EA113-1.6 series: AHL AKL ALZ ANA APF ARM AVU BFQ BGU BSE BSF

Audi Bht engine

The 6.0-liter 12-cylinder engine Audi A8 W12 BHT was produced from 2003 to 2010 and installed in the expensive versions of the A8 sedan with the D3 body, including the extended version A8L. Other variants of this engine, labeled BTE and BSB, were also mounted in this model. The EA398 series also includes engines: BDN, BRN, and CEJA.

Audi Asn engine

The 3.0-liter, 30-valve Audi ASN 3.0 V6 engine was installed by the company from 2000-2005 and used in advanced versions of popular models such as the A4, A6, and A8. There was also a downgraded version of this engine labeled as BBJ, intended for developing countries. The EA835 engine line also includes the following power units: ALF, ARE, BDV, ABC, AAH, ACK, ALG, and BBJ.

Audi Ctsa engine

The 2.5-liter turbocharged engine Audi CTSA or RS Q3 2.5 TFSI was produced from 2013 to 2015 and only installed in the RS version of the Q3 model with body type 8U. Updated versions of this engine with power outputs of 340 HP and 367 HP have the indexes CZGA and CZGB. The EA855 engine family also includes the following power units: CEPA, DAZA, and DNWA.

Nissan - Renault M9r Engine

The 2.0-liter diesel engine Nissan and Renault M9R or 2.0 dCi has been produced since 2005 and is installed in popular models such as Espace, Koleos, Talisman, as well as Qashqai and X-Trail. There are two generations of this engine, which can be distinguished based on their displacement: 1995 cc and 1997 cc. The M-Series engine range also includes: M4R and M9T.

VW BKP engine

The 2.0-liter Volkswagen BKP 2.0 TDI engine was produced by the company from 2005 to 2008 and installed in the fairly popular Passat model in the secondary market with the B6 body. This diesel engine stood out from others due to the use of piezoelectric injectors. The following engines belong to the EA188-2.0 line: - BKD, - BMM, - BMP, - BMR, - BPW, - BRE - BRT.