The 1.6-liter petrol engine Jeep EJH or 1.6 E.torQ has been manufactured in Brazil since 2011 and is used in the Renegade crossover, as well as in some Fiat models such as the 500X, Siena, Punto, and Palio. This power unit is actually a modernized version of the popular Tritec engine. Currently, there is only one engine available in the E.torQ series.
| Exact capacity | 1598 cm³ |
| Power system | injector |
| Engine power | 110 HP |
| Torque | 152 nm |
| Engine block | aluminum R4 |
| Block head | aluminum 16v |
| Cylinder diameter | 77 mm |
| Piston stroke. | 85.8 mm |
| Compression ratio | 11 |
| Engine features | SOHC |
| Hydraulic compensator. | tak |
| Timing drive | chain |
| Timing phase adjuster | there is no |
| Turbocharging | there is no |
| What oils to use | 4.6 liters 5W-30 |
| Fuel type | 95 |
| Environmental class | EURO 5 |
| Approximate life expectancy | 250 000 HP |
| City | 8.8 litry |
| Route | 5.1 litry |
| Mixed | 6.5 litry |
The weight of the EJH engine according to the catalog is 127 kg. The engine number EJH is located at the joint of the block with the cylinder head. This power unit has been in production for a relatively short time, and there is not yet any statistics on breakdowns. It is only installed on the Jeep Renegade, and its owners do not complain much about it. The only downside could be considered its mediocre power characteristics. In principle, this engine is designed for third world countries, where it has gained popularity.
| Renegade 1 (BU) | 2014 - CE |
The 2.5-liter gasoline engine Jeep EPE or AMC 150 was produced from 1983 to 2002 and installed in popular off-road vehicles of the company, such as Wrangler, Comanche, and Cherokee. Until 1985, a carburetor was used, then in the 1990s, a single-point fuel injection TBI appeared, and later a multipoint injection MPI. The AMC series also includes the ERH engine.
The 3.0-liter V6 Jeep EHD engine is produced by an American company since 2014 and is installed in the large SUV Grand Cherokee in the WK2 version in certain markets. This power unit is also used in Chinese versions of the Wrangler off-road vehicle or the 300C sedan. Other engines in the Pentastar series include: EHB, ERB, and ERC.
The 3.2-liter V6 gasoline engine Jeep EHB is produced and assembled by an American company since 2013 exclusively for the popular Cherokee crossover in its KL version in certain markets. This engine is also used in our models and has gained wide popularity. The Pentastar series also includes the following engines: EHD, ERB, and ERC.
The 4.7-liter V8 engine Jeep EVС or PowerTech High Output was produced from 2002-2008 and installed in the Grand Cherokee SUV, as well as briefly in the Ram and Dakota pickups. This engine not only had more power but also featured a knock sensor. The PowerTech series also includes the engines: EKG, EVA, and EVE.
The 1.3-liter engine Ford A9JA, A9JB or Zetec RoCam 1.3 was produced from 2001 to 2008 and exclusively installed in the fifth generation Fiesta hatchback version with three or five doors. This power unit is officially referred to by the company as Duratec 8v in its catalogs. Also, belonging to the Zetec RoCam line is the engine: CDDA.
The 2.5-liter flat-six engine Porsche M96.20 was produced by the company from 1996 to 1999 and installed in the base versions of the first-generation Boxster convertible with the 986 body. The engines from the early years had many issues due to the low quality of the cylinder block casting. The M96 line also includes: M96.22 and M96.26.